S.L. 427.35 Art. 37Penalties. Cap. 427. 1. Equipment the art, as to (a) (b) 2. Installation A fixed respecting the meeting the 1. the Schedule, and concerned 2. The the apparatus, essential The intended configurations, the apparatus the possible intended use. 3. The shall make requirements, The as far as apparatus. Th

Economic operators failing to comply with the requirements of these regulations are subject to the provisions of article 26 of the Product Safety Act. SCHEDULE I

ESSENTIAL REQUIREMENTS General requirements shall be so designed and manufactured, having regard to the state of ensure that: the electromagnetic disturbance generated does not exceed the level above which radio and telecommunications equipment or other equipment cannot operate as intended; it has a level of immunity to the electromagnetic disturbance to be expected in its intended use which allows it to operate without unacceptable degradation of its intended use. Specific requirements for fixed installations and intended use of components installation shall be installed applying good engineering practices and information on the intended use of its components, with a view to essential requirements set out in point 1.

SCHEDULE II MODULE A: INTERNAL PRODUCTION CONTROL Internal production control is the conformity assessment procedure whereby manufacturer fulfils the obligations laid down in points 2, 3, 4 and 5 of this ensures and declares on his sole responsibility that the apparatus satisfy the requirements of these regulations that apply to it.

Electromagnetic compatibility assessment manufacturer shall perform an electromagnetic compatibility assessment of on the basis of the relevant phenomena, with a view to meeting the requirements set out in point 1 of Schedule I.

electromagnetic compatibility assessment shall take into account all normal operating conditions. Where the apparatus is capable of taking different the electromagnetic compatibility assessment shall confirm whether meets the essential requirements set out in point 1 of Schedule I in all configurations identified by the manufacturer as representative of its

Technical documentation manufacturer shall establish the technical documentation. The documentation it possible to assess the apparatus conformity to the relevant and shall include an adequate analysis and assessment of the risk(s). technical documentation shall specify the applicable requirements and cover, relevant for the assessment, the design, manufacture and operation of the technical documentation shall, wherever applicable, contain at least elements:

general description of the apparatus; conceptual design and manufacturing drawings and schemes of components, sub-assemblies, circuits, etc.;

(c) descriptions and explanations necessary for the understanding drawings and schemes and the operation of the apparatus;

(d) a list of the harmonised standards applied in full references of which have been published in the Official European Union and, where those harmonised standards applied, descriptions of the solutions adopted to meet requirements of these regulations, including a list of technical specifications applied. In the event of harmonised standards, the technical documentation shall parts which have been applied;

(e) results of design calculations made, examinations carried

(f) test reports.