S.L. 427.22 ст. 2for each wire- his authorized or left hand nature and of strands, with principal breakage under the wire-rope; internal and quality of the piece and that tortion and international

Provisions concerning wire-ropes 2.1. The manufacturer or his authorized representative must issue rope a certificate containing at least the following information:

(a) compulsory information: - the name and address of the manufacturer or representative; - the nominal diameter of the wire-rope; - the length of the wire-rope delivered; - the average mass per metre; - the mode type and direction of lay of the cable (right lay, preformed or not, crossed or Lang’s lay); - length of the lay of the cable; - the construction (composition of the wire-rope, composition of the core of the wire-rope, number number of wires); enclose drawing of cross-section dimensions; - the characteristics of the steel (class or quality); - the nominal tensile breaking strength of the wires; - the lowest practical resistance of the wire-rope to tension; - the minimum practical tensile breaking strength of - information on the nature of the protection against external corrosion (in the case of galvanizing, the zinc coating must be stated); - the certificate that the wire-rope is made in a single its characteristics are constant throughout its length; - information on the nature and methods of the tension, bending tests, and the results thereof; - the temperature limits for use of the wire-rope; - maintenance and inspection instructions;

(b) information where applicable: - if the wire-rope is made according to a national or standard, identify this standard.